HVAC Repair in Warsaw, IN
Homes here need heat from October through May and cooling from June through August. If your system quits, tell us what it's doing and a licensed contractor who covers Kosciusko County will get in touch.
Tell us about the job
It takes about a minute.
Eight months of heat, three of cooling, and not much rest between
Your furnace in Kosciusko County works from October through May, and most of those nights sit around 20°F. That means long stretches where the burner cycles on and off for hours, over and over, and every start puts wear on the igniter and the ignition control board. When one of those parts finally gives out, the furnace won't light at all and the house goes cold fast at that temperature.
Come summer, your air conditioner has a shorter job but a harder one, cooling against afternoons averaging 82°F for three months straight. That steady load stresses the compressor and can leave the coil struggling to keep up. Add in the wind this area sees, 117 damaging wind events over the past ten years, and outdoor units take a beating too, from debris hitting the coil to power interruptions that can trip a unit off entirely. With 17% of Indiana households losing power for a full day or more last year, it's worth knowing that most systems restart on their own once power is back, but the storm itself can still leave a unit needing a look before it runs right again.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 20°F
- the average winter night it heats against
- 82°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $130 a year off heating and cooling for a typical Kosciusko County home.
Estimates for a typical Kosciusko County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Indiana fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
In Indiana, HVAC licensing for homes is left to the counties and cities.
Indiana has no state HVAC license. That rule is left to counties and cities instead, so whether Kosciusko County or a city within it requires anything of a contractor is a local question, not a state one. Some local offices test and license before a contractor can work, some just keep a registry of businesses with nothing tested, and some have no rule at all. There is no statewide record either way, only whatever the county or city keeps on file.
On a repair like this, gas piping or a gas connection is the part where a mistake is dangerous, and whether that gets checked here comes down to whatever Kosciusko County or its local building office requires, since Indiana itself has no license standing behind the work.
Sources: Indiana Department of Workforce Development · State of Indiana
- Why is my heat not working?
- Start with the thermostat. Check that it's set to heat, not just fan, and that the temperature is set above the room temperature. If that's fine, check your breaker panel and any switch near the furnace that looks like a light switch, since that shuts the whole unit off if it's flipped. Gas furnaces also need the pilot light or igniter to work, so if you hear the blower running but no heat comes out, that's usually where the problem is. At 20°F on a winter night here, a furnace that won't fire is worth calling in fast.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow across the coil, and when that happens the coil can freeze over and stop cooling the air at all. Next check that the outdoor unit isn't blocked by leaves, grass clippings or anything piled against it, since it needs open air around it to release heat. If the filter is clean and the outdoor unit is clear, the system may be low on refrigerant, and that's not something to add yourself. It takes a contractor to find the leak and recharge it properly.
- What can I check before calling for HVAC repair?
- Check the thermostat settings, the batteries in it if it uses them, and the breaker for the unit. Check the air filter next and replace it if it's dirty, since that alone causes a lot of the no-heat and no-cool calls. Look at the outdoor unit for anything blocking it, and check that any switch near the indoor unit hasn't been bumped off. If none of that turns anything up, a contractor will need to look at it, and having noticed these things first will help them get to the actual problem faster.